Starting a new Project with the LattePanda Alpha

This is a great little SBC and is due to be in general release in late December 2018.  I 3D printed a case and had it up and running with MS Window 10 Pro in about 15 minutes.  I added a 500Gb M.2 SATA SSD drive to the connector on the rear of the board, the intention is to Dual Boot with Windows 10 Pro and Ubuntu 18.04.  I have not setup the WIFI yet, selecting instead to use the Ethernet port.

This

On the rear of the board you can see the 2x M.2 ports as well as connections for Touch Panel Display and several other features.  Documentation is a little sparce  at this point however.

Leave a Reply